Search This Blog

Tuesday, October 21, 2014

Make Hay While the Sun Shines


Always wished you knew more about how all those bales sitting in the fields as you drive by are made? Did FFT member Bruce Figger’spost back in August really spark your interest in the baling process? If so, today’s your lucky day. J Many things can be baled and used as feedstuffs for cattle. I’m just going to go through a quick overview of the general process for those that aren’t very familiar with it.
A swather is used to lay down whatever crop you want to bale. When using a sickle swather like the one shown below, the sickles on the front of the swather header cut the hay at its base and an auger moves everything to the middle of the header where the conditioner is located. The conditioner crimps the stalk of the plant to allow air access for faster drying. This leaves windrows of hay in the field, and the bigger the swather header, the more hay there is in a windrow. The length of time that the windrow lays out to dry before being baled depends on the crop, size of the windrow, and the weather and climate conditions. If the hay is too wet when being baled, mold can grow within it, decreasing the quality. If baled too dry, quality is decreased due to loss of nutrient-rich leaves.


New Holland sickle swather

Swather cutting sorghum Sedan grass
Windrows after swathing in beautiful western Kansas!
Once the hay is dry enough, we are ready to rake and bale! Usually one person operates the rakes with the baler operator not far behind. The rakes speed up the baling process by combining two windrows into one. When baling sorghum sedan grass, as shown above, rakes may be needed to help dry out the windrow by rolling it over a couple days prior to baling.
Rakes in action

The windrow is gathered by a pickup attachment in the front of the baler and the hay is delivered into the baler where a series of belts begin rolling it into a tightly wrapped bale. There is a tensioner roller inside the baler that keeps the belts wrapped securely around the hay to ensure that the bale is packed tight from the beginning of the process to the end.

There is a sensor within the baler that will tell the operator when the bale is at the desired height. At this point, the baler will wrap the bale with either twine or net wrap. After the bale is wrapped, the operator can drop the bale out of the baler onto the field. Net wrap is used more commonly than twine because it is more efficient. This process is continued until all the windrows have been picked up and turned into bales!
This photo isn't mine but wanted you to be able to see a freshly made round bale being dropped out of a baler.
Source: ttp://www.rspb.org.uk/community/cfs-file.ashx/__key/communityserver-blogs-components-weblogfiles/
Such a pretty sight!
Hope this was as interesting to you guys as it is to me. J

Keep calm and bale on,

Tonia
 

2 comments:

  1. Those round bales aren't allowed in Wisconsin ... we want our cows to have 3 square meals a day

    ReplyDelete

LinkWithin

Related Posts with Thumbnails